Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 9
IM CX2000-S30E
7
g) XU: Sets the channel identification display, memory alarm time, language, whether or
not to use the partial expanded display function and the batch function
Syntax XU p1, p2, p3, p4, p5, p6
p5: batch function use or not (USE, NOT)
p6: specify message display mode (COMMON, SEPARATE）
h) SO: Sets the computing equation
Syntax SO p1, p2
, p3, p4, p5, p6, p7
p3 computing equation (Max 120 characters)
- CI01-CI10, W01-W36, DO/DI/SW data, CLOG.MAX(),
CLOG.MIN(),CLOG.AVE(). CLOG.P-P(), and [eq1?eq2: eq3]can be
used in computing equation
.
i) GN: External loop parameter 2, alarm number/alarm type
Syntax GN p1, p2, p3
p2: Number of alarm
UT130, UT150, UT152, UT155: 1-2
p3: Alarm type (only additional alarm type is described
PV-velocity, PV-velocity (Deenerg), Self-diagnostic, Self-diagnostic
(Deenerg), Timer-function, Heater-burnout
j) GW: External Loop Setting (Parameter Address Setting)
Syntax GW p1, p2, p3
For UT100 series, p2 is as follows.
p2: parameter kinds: PV, SP, OUT, Alarm, SP. No, AT
k) YL Sets the operation of the Modbus master function
Syntax YL p1,p2,p3
p1: 10 min
p2: 2min