Pfister 049-CNFC User Manual

Page 6

10 FLUSHING & AERATOR CLEANING

(Fig.F)

After installation is complete, remove Aerator Housing.

Turn valve on and allow both hot and cold water to run for

at least one minute each. While water is running, check for

leaks. To clean the Aerator, disassemble Aerator Housing

by separating the Aerator Head (1), Basket (2) and

Washer (3). Once parts have been cleaned, reassemble

by reversing steps.
11 CARTRIDGE REMOVAL (Fig.G)

Turn off water supplies and relieve pressure before

working on your Faucet! Remove Plug (1). Loosen Set

Screw (2) and remove Handle (3). Remove Washer (4)

and Handle Body (5). Carefully remove the Cartridge (6)

by pulling it straight up and out. Reassemble valve by

reversing steps.

CAUTION: Maintenance

DISASSEMBLY

1. Replacement parts may be available at the store where

you purchased your faucet.

2. When replacement parts are not available, please write or

call Price Pfister Consumer Service.

3. Always turn off water and relieve pressure before

working on your faucet.

NOTE: Trim Care

Cleaning Instructions:

For all handles and decorative finishes, use only a soft damp

cloth to clean and shine. Use of polish, detergents, abrasive

cleaners, organic solvents or acid may cause damage. Use

of other than a soft damp cloth will nullify our warranty!

Special Trim:

Trim products which contain porcelain or other similar

substance are not acceptable for public areas or Commercial

use. Installation of Said Trim is at Users Risk!