Watlow Silver Series OIT - Manual (Page 11)

11 Watlow Silver Series OIT Installation Guide
0600-0069-0000 Rev D
Caution: Do not over-tighten the screws beyond snugness, or
you may damage the housing.
REINSTALLATION: If, at anytime, you are required to reinstall an OIT
into a panel, be aware that the gasket will take a ‘set’ to the panel and
may no longer provide an adequate NEMA 4 seal Therefore, for best
results, we recommend that you replace the gasket if reinstallation is
required.
Configuration Wiring
To configure the OIT using the EZware-5000 software, you will need the
correct configuration cable for your OIT. Please refer to the following
table for configuration cable options.
OIT Model Ethernet Cable
USB Cable
P/N
0210-0382-0000
TS00-0043-0000 (HMI5043N) X
TS00-0043-E000 (HMI5043T) X
TS00-0070-0000 (HMI5070TH),
TS00-0100-0000 (HMI5100T)
X X
Ethernet
If using a switch or router between the PC and the OIT, use a straight-
through or crossover cable as required by the switch or router.
USB
A USB driver (included with the EZware-5000 software) must be
installed when downloading from the PC to the OIT via a USB
connection. To install the USB driver, please refer to the help file ‘How
Do I’ section in EZware-5000 for detailed step-by-step instructions.