Watlow DIN-A-MITE Style D - Manual (Page 6)

6 WATLOW DIN-A-MITE Style D User’s Manual
Declaration of Conformity
DIN-A-MITE ® “D” Power Controller
WATLOW
an
ISO 9001
approved facility since 1996.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following product:
Designation: DIN-A-MITE® “D” Power Control
Model Numbers: DD10 – (02, 24, 48 or 60)(CX, K1, K2, K3, FX) – (0, 1, S)(followed by any 3
numbers or letters.) X = any number 0-9
Classification: Power Control, Installation Category III, Pollution degree II, IP00
Rated Voltage: 24 to 600 V~ (ac), 50/60 Hz
Meets the essential requirements of the following European Union Directives by using the relevant
standards show below to indicate compliance.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326-1: 2005 Electrical equipment for measurement, control and laboratory use
– EMC requirements (Industrial Immunity, Class A
1,2,4 Emissions)
Not for use in a Class B environment without additional filtering.
EN 61000-4-2:1996 +A1,A2 Electrostatic Discharge Immunity
EN 61000-4-3:2006 Radiated Field Immunity 10V/m 80 MHz- 1GHz, 3V/m 1.4GHz-2.7GHz
EN 61000-4-4:1995 Electrical Fast-Transient / Burst Immunity
EN 61000-4-5:1995 +A1,A2 Surge Immunity
EN 61000-4-6:1996 +A1,A2,A3 Conducted Immunity
EN 61000-4-11:2004 Voltage Dips, Short Interruptions and Voltage Variations
EN 61000-3-2:2005 Harmonic Current Emissions
EN 61000-3-3:2005
EN 61000-3-11:2001 Voltage Fluctuations and Flicker 3 ” 16A
Voltage Fluctuations and Flicker ” 75A with conditional connection
NOTES
1 Use of an external filter is required to comply with conducted emissions limits. See note 4 below.
2 A Line Impedance Stabilization Network (LISN) was used for conducted emissions measurements.
3 To comply with flicker requirements, command signal models FX will require a reduced source
impedance. Cycle time on ON/OFF models CX and K1, K2, K3 may need to be up to 175 seconds at
16A or have a reduced source impedance.
4 Required External EMI Filters for DIN-A-MITE with More Than 6 Amp Loads
2006/95/EC Low-Voltage Directive
EN 50178:1997 Electronic equipment for use in power installations.
Per 2002/96/EC W.E.E.E Directive Please Recycle Properly.
These devices contain lead solder and are not RoHS compliant.
They are a Control Device and fall outside the scope of 2002/95/EC Directive.
Raymond D. Feller III Winona, Minnesota, USA
Name of Authorized Representative Place of Issue
General Manager
January 2009
Title of Authorized Representative Date of Issue
Signature of Authorized Representative