Rapid-Air PALLET MASTER (PMD): PMD35 & PMD50. 115VAC, 1PH, 60HZ - Manual (Page 24)

Rapid Air Corporation
electric motors, switches, coils solenoids and/or relays. Eye protection must be
worn when working with control under power. This product is constructed of
materials (plastics, metals, carbon, silicon, etc.) which may be a potential hazard.
Individual material safety data sheets (MSDS) are available upon request. Proper
shielding, grounding and filtering of this product can reduce the emission of radio
frequency interference (RFI) which may adversely affect sensitive electronic
equipment. If information is required on this product, contact our factory. It is
the responsibility of the ultimate user of this product to read and comply with this
safety warning. (SW effective 1/89)
***IMPORTANT***
YOU MUST READ THESE INSTRUCTIONS BEFORE OPERATING
CONTROL
1. Be sure AC line voltage corresponds to control voltage.
2. Install the correct Plug-In Horsepower Resistor according to armature
voltage and motor horsepower.
3. Recheck connections: AC line to L1 and L2; armature to A+ and A– and
field (Shunt motors only to F+ and F-.) (Note: If motor runs in improper
direction, interchange armature leads.)
4. Install proper AC line fuse and armature fuse as required.
file:///C|/Web_develop/Pallet%20Master.htm (27 of 46) [12/10/2001 3:38:23 PM]