Rapid-Air PALLET MASTER (PMD): PMD35 & PMD50. 115VAC, 1PH, 60HZ - Manual (Page 15)

Rapid Air Corporation
1. Switch “ON”
2. RUN/STOP/JOG - “RUN”
3. Slowly push (rotate) the control arm toward the turntable to start the
rotation.
A. If the table turns in the wrong direction, turn power switch “OFF” and
reverse the rotation direction switch. Then turn switch “ON”.
B. The turntable speed should increase as the control arm is moved
toward the table.
OPERATION
1. Place the coiled stock on the turn table. Center the material on the turn
table so the coils are concentric with the table.
2. Rotate the table slowly by pushing the control arm toward the turn table.
Unwind the first coil until the material can be threaded around the roller and
back toward the press. The control arm and turn table will now operate
automatically.
3. Slowly walk the material to the press. An alternative means of moving the
material toward the press is to turn the RUN/STOP/JOG switch to jog and the
push the jog button. This may be a preferred method since this function
overrides the control arm that may not be properly set at this time. See
optional equipment.
4. RUN/STOP/JOG - “STOP”
5. Adjust the roller angle so that the material makes full contact on the spool.
file:///C|/Web_develop/Pallet%20Master.htm (18 of 46) [12/10/2001 3:38:23 PM]