Ramsey Winch RPH-40000 2 SPEED W/AIR TENSIONER - Manual (Page 9)

7
5. Pull drum assembly #1 upward from end bearing #10. Remove quad-rings #42 from grooves in
drum bushings. Remove input shaft #12, clutch springs #46 & #47 and washers #28 & #30 from
end bearing. Examine splined ends of input shaft for signs of wear, replace if damaged.
Examine drum assembly #1 for signs of wear. If splines inside of drum driver (332148) are
damaged, drum driver must be replaced. Remove drum driver by unscrewing (8) capscrews
(414978). If bushings show signs of wear, replace by pressing old bushings from drum and
removing o-rings from grooves in drum and drum driver. Place well-oiled o-rings (462043) into
grooves in drum and drum driver. Press new bushing (412078) into end of drum opposite drum
driver and press bushing (412079) into drum driver until flange of bushings are flush against drum
and driver.
DRUM BUSHING
ASSEMBLY
11
12
46
28
47
DRUM DRIVER
GROOVE
O-RING
462043
1
10
30
42
BUSHING
412078 42
1
BUSHING
412079
O-RING
462043