Ramsey Winch RPH-40000 2 SPEED W/AIR TENSIONER - Manual (Page 10)

8
6. Remove output coupling #6 and coupling shaft #7 from end
bearing #10. Examine bearings #14 pressed in output
coupling for signs of wear. Replace bearings, if necessary,
by pressing old bearings from coupling and press new
bearings into each end of output coupling. Place coupling
shaft into bearings.
7. Remove (12) capscrews #17 to pull gear-housing cover #4
and gasket #37 from ring gear #51. Remove input thrust
washer, sun gear and carrier assemblies from inside of ring
gear. Remove ring gear #51 and gasket #37 from end
bearing #10. Examine shifter shaft #13 for signs of wear,
replace if necessary. Examine bushing #15 for signs of
wear. Replace bushing, if necessary, by pressing old
bushing from housing and pressing new bushing into place.
14 10
14
6
7
10
13
37
15
50
4
37
51
17