Ramsey Winch RPH-20000 (SPEC. FOR CHEVRON) - Manual (Page 9)

7 OM-914032-0503-D
5. Pull drum assembly (item #2) upward from end bearing (item #9). Remove quad-rings (item #39 &
#38) from grooves in drum bushings. Remove input shaft (item #11), clutch spring (item #45) and
washer (item #27) from end bearing (item #9). Examine splined ends of input shaft for signs of
wear, replace if damaged.
Examine drum assembly (item #2) for signs of wear. If splines inside of drum driver (332166) are
damaged, drum driver must be replaced. Remove drum driver by unscrewing (8) capscrews
(414462). Place well-oiled o-ring (462053) into drum driver groove and attach driver to drum
(332165) using (8) capscrews (414462). Torque capscrews to 55 ft. lbs. each, in criss-cross
pattern.
Press old bushings from drum and drum driver. Remove o-rings (462055 & 462052) from grooves
in drum and drum driver-bushing (412092). Place well-oiled o-rings (462055 & 462052) into
grooves in drum and outer diameter of drum driver bushing (412092). Press new bushing
(412091) into end of drum opposite drum driver and press bushing (412092) into drum driver until
flange of bushings are flush against drum and driver. Secure bushings to drum and drum driver
using (2) capscrews (414819).