Ramsey Winch RPH-20000 (SPEC. FOR CHEVRON) - Manual (Page 14)

12 OM-914032-0503-D
15. Apply Permatex to threads of pipe cap (item #43). Thread pipe cap onto pipe nipple in
bottom of gear housing end bearing (item #9). Pour approx. 1.75 pints of SAE 80W-140 oil into
end bearing. Check oil level by removing oil plug noted below. Insert relief fitting (item #35) and
thread reducer (item #41) into end bearing at oil fill hole.
Install winch and connect pressure lines. Apply at least 230 PSI pressure to release brake and
verify that brake releases, by observing that the winch drum rotates.