Ramsey Winch RPH-20000 (SPEC. FOR CHEVRON) - Manual (Page 10)

8 OM-914032-0503-D
6. Remove output coupling (item #7) and coupling shaft (item #6) from end bearing (item #9).
Examine bearings (item #13), pressed in output coupling (item #7), for signs of wear. Replace
bearings, if necessary, by pressing old bearings from coupling and press new bearings (item #13)
into each end of output coupling (item #7). Place coupling shaft (item #6) into bearings (item
#13).
7. Remove (8) capscrews (item #15) to pull gear-housing cover from ring gear. Remove input thrust
washer, sun gear, carrier assemblies, and spacer (item #13) from inside of ring gear. Examine
splines of ring gear and if necessary, remove ring gear from end bearing (item #9) by removing
(12) capscrews (item #16). Examine bushing (item #14) for signs of wear. Replace bushing, if
necessary, by pressing old bushing from housing and pressing new bushing into place.
Apply RTV sealing compound to ring gear-mounting surface of end bearing (item #9). Place ring
gear onto end bearing, aligning holes in ring gear with holes and gear housing end bearing.
Secure ring gear to end bearing using (12) capscrews (item #16). Torque to 44 ft.lbs, each in a
criss-cross pattern. Examine shifter shaft (item #12) for signs of wear, replace if necessary.