Ramsey Winch RPH-45000T - Manual (Page 14)

11
12. Gently tap key #5 into keyway of input shaft #11. Liberally apply grease to shoulder of input shaft.
Place 1-3/4 OD washer #27 over end of shaft and against shoulder of shaft. Place spring #45
inside of spring #46 and place both springs over shaft and against washer #27. Slide 2-3/8 OD
clutch washer #24 over splined end of shaft and against springs. Use grease to hold springs and
washers in place on shaft. Place splined end of shaft through drum and into output coupling #7.
Mesh spline of input shaft with internal spline of coupling shaft inside of drum.
Align keyway of coupling with key and end of input shaft. Slide coupling over end of shaft #11.
Place gasket #34e into position on motor mounting surface of end bearing #9. Use (2) screws #18
to attach brake adapter plate #34d to motor end bearing. Torque capscrews to 85 ft-lbs. each.
Place second gasket #34e on adapter plate. Insert brake shaft with key #34c into coupling. Use
(2) capscrews #50 to attach brake to adapter plate. Torque capscrews to 97 ft-lbs. each.
Note: Care must be taken to assure brake and adapter plate are seated properly prior to installing
1/2-13NC assembly bolts. Damage will occur to rotor stack or shaft snap ring if not properly
installed.
13. Attach motor #40 with well oiled gasket #34b to
brake #34. Use (2) capscrews #19 and torque
to 74 ft-lbs. each. Securely connect tube #47 to
elbow #31, in bottom of valve #48, and fitting
#32 in bottom of brake #34.
48
34
19
40
19
47
34b
45
44
5
50
18
18
34e
34d
34e
34a
32
34c
50
8
9
27
24