Ramsey Winch RPH-45000T - Manual (Page 11)

8
6. Remove output coupling #6 and coupling shaft #7 from end
bearing #10. Examine bearings #13 pressed in output coupling for
signs of wear. Replace bearings, if necessary, by pressing old
bearings from coupling and press new bearings into each end of
output coupling. Place coupling shaft into bearings.
7. Remove (12) capscrews #15 to pull gear-
housing cover and gasket from ring gear.
Remove input thrust washer, sun gear
and carrier assemblies from inside of ring
gear. Remove ring gear #4 and gasket
#35 from end bearing #10. Examine
shifter shaft #12 for signs of wear, replace
if necessary. Examine bushing #14 for
signs of wear. Replace bushing, if
necessary, by pressing old bushing from
housing and pressing new bushing into
place.
13 10
13
6
7
10
12
35
GEAR HOUSING
COVER
4
14
RING GEAR
15