Ramsey Winch RPH 10000XT - Manual (Page 13)

11
Remove o-ring (item #36) and bushing (item #15) from motor end bearing (item #7).
Press new bushing onto end bearing and dip o-ring in oil and seat into groove of end
bearing. Remove seal (item #45) from gear housing end bearing (item #8). Loosen nut
(item #27) and remove nylon setscrew (item #22) and remove ring gear (item #6) from
gear housing end bearing, if necessary. Remove bushing (item #16) from gear housing
end bearing (item #8). Press new bushing (item #16) into place in end bearing. Install
ring gear and nylon setscrew and nut. Ring gear must be fully seated in gear housing
end bearing (item #8) and slot in ring gear must NOT be aligned with clutch shifter hole.
Install new seal in gear housing end bearing, with sharp edge of seal outward.