Ramsey Winch RPH 10000XT - Manual (Page 12)

10
Remove brake housing (item #9) from end bearing (item #8) by unscrewing (4) capscrews
(item #23). Remove plate (item #12) and light assembly, if present remove gasket (item
#33), coil spring (item #48), flat spring (item #3), retainer plate (item #11), composition
brake discs (item #32) and cam plate (item #4). Remove hub plate (item #10) and brake
shaft (item #51) with plug (item #42), which is press-fitted in the hub plate I.D. Inspect the
seal (item #37), inside of gear housing bore, and replace if necessary.
Inspect brake discs. Discs are 1/4" thick when new, replace if thinner than .200 in. thick or if
surfaces are glazed or burnt. Inspect the flat ground surfaces of the cam plate and retainer
plate for glazing, warping or other damage. Glazing can be removed by scraping carefully.
Inspect flat spring. It should be bowed at least 1/8". Replace spring if bowed less than 1/8".
Replace all worn or damaged parts as needed. Reassemble all parts as shown. Be sure
balls are secure between cam plate and hub plate.
Install brake housing, making sure that ends of capscrews (item #17) go through notches in
end of flat springs and holes in the retainer plate. Secure brake housing and plate (item
#12), if present, to end bearing using capscrews (item #23). Tighten capscrews to 30-40
FT.LBS.