Ramsey Winch RPH 10000XT - Manual (Page 11)

9
Remove tie plates (item #14) from end bearings (items #7 & #8) by unscrewing
capscrews (item #19), as shown. Slide motor end bearing (item #7) from drum (item #1)
and drum from gear housing end bearing (item #8). Remove input shaft (item #12) from
end bearing. Inspect teeth of gear (item #5) for signs of wear. If necessary replace gear
by removing snap ring (item #48) and thrust washer (item #51) . Slide new gear over
splines of shaft and against snap ring on shaft. Re-install thrust washer and place snap
ring into groove of shaft.