Ramsey Winch RPH 133,4 - Manual (Page 14)

12. Align key way of coupling with key on end of input shaft inside end bearing assembly. Slide coupling over end of
shaft. Place gasket item #38e into position on motor mounting surface of end bearing item #10. Use (2)
screws item #23 to attach adapter plate item #38d to motor end bearing. Torque capscrews to 115 Nm (85 ft
lb) each. Place second gasket item #38e on adapter plate. Insert brake shaft with key item #38c into coupling.
Re-attach brake item #38a to adapter plate using brake assembly screws item #18. Torque capscrews to 132
Nm (97 ft lb) each.
Note: Care must be taken to assure brake assembly and adapter plate are seated properly prior to installing
assembly bolts item #18. Damage will occur to rotor stack or shaft snap ring if not properly installed.
13. Attach motor item #43 with gasket item #38b to brake item #38. Use (2) capscrews item #24 and
torque to 100 Nm (74 ft lb) each. Securely connect tube item #50 to elbow item #35 in bottom of
valve and fitting item #36 in bottom of brake item #38.
11