Ramsey Winch RPH 133,4 - Manual (Page 12)

8. NOTE: DETERMINE MOUNTING CONFIGURATION OF WINCH (R.H. or L.H. MOUNTED) BEFORE ATTACHING UPRIGHT
FRAME TO WINCH, TO ASSURE PARTS ARE MOUNTED TO PROPER SIDE, REFER TO WINCH MOUNTING CONFIGU-
RATIONS, STEP 16 PAGE 12.
Seat well oiled quad-rings item #44 & #45 into groove of bushing in each end of drum assembly item #1,
as shown. Carefully set drum assembly item #1 down over motor end bearing item #10. Lift gear housing
end bearing item #11 and set into place on drum assembly. Attach upright frame item #2 to end bearings.
Install (4) shoulder bolts item #32 and hand tighten. Install (8) capscrews with lockwashers item #20 &
#29. Tighten (4) inner-most capscrews securely, check rotation of rope drum. Tighten (4) outer-most cap-
screws securely, check rotation of rope drum. Torque capscrews, in previous inner-most then outer-most
pattern, to 339 Nm (250 ft lb) each. Torque (4) shoulder bolts to 41 Nm (30 ft lb) each. Make sure rope
drum assembly rotates freely at this point.
9. Gently tap key item #12 into keyway of input shaft item #13. Liberally apply grease to shoulder of input
shaft item #13. Place spring item #49 over splined end of shaft. Use grease to hold spring in place on
shaft. Place spring and splined end of shaft through motor end bearing item #10 and drum until shaft
extends through bushing item #16. Place clutch washer item #33 over splined end of shaft and against
spring.
Place end of output coupling assembly item #9, with longest splines, through end bearing bushing item
#16 and mesh shaft coupling spline with splined end of shaft. Place short splined end of shifter shaft item
#14 through washer item #33 and into shaft coupling item #7, meshing splines of shifter shaft with splines
in shaft coupling.
9