Ramsey Winch FORD QM KIT 295375 - Manual (Page 5)

4
STEP 5
Use (2) 1/2-13NC x 1.5” capscrews #7 with (2) lockwashers #13 and (2) flat washers #14 through
bottom of vehicle frame and into rear nutserts of nut plate attached to mounting arm assemblies #4 &
#5, each side. Tighten all hardware to full torque.
STEP 6
Drill (2) 9/16 DIA. holes through bumper brackets, as shown below. Use mounting arm flanges #4 &
#5 as a template.
Install (2) 1/2-13NC x 1.75”. capscrews #8 with (2) flat washers #134 (2) lockwashers #13 and (2)
nuts #11, each side as shown below. Install vehicle tow hooks to inside of mounting arms #4 & #5
using M12 x 1.75 x 30mm capscrews #10. Tighten to full torque.
REFER TO WINCH OWNER'S MANUAL FOR INSTALLATION INSTRUCTIONS AND ELECTRICAL CONNECTIONS
7 13 14 4
DRILL (2) 9/16" DIA. HOLES
THROUGH HOLES IN MOUNTING
ARM FLANGES AND INTO
VEHICLE BUMPER BRACKET.
VEHICLE TOW HOOKS
RECEIVER NOT SHOWN FOR CLARITY
8
10
14
11 13