Ramsey Winch FORD QM KIT 295375 - Manual (Page 3)

2
STEP 3
Remove R.H. vehicle bumper bracket bolts (2 bolts) and discard.
Secure R.H. mounting arm #4 to vehicle frame using (2) 1/2-13NC x 1.75” capscrews #8, (2) nuts
#11, (2) lockwashers #12, (1) nutplate #3 and (2) flat washers #13 as shown below. These
capscrews go through the outside (slotted) holes on the mounting arm flanges.
HINT: To align holes between mounting arm flanges, bumper bracket, and frame, you may need to
raise or lower the bumper slightly.
Repeat for L.H. bracket assembly #5.
REMOVE EXISTING
HARDWARE
5
4
11 13
14 8
VEHICLE FRAME
OUTSIDE MOUNTING
HOLES IN BRACKETS
ARE SLOTTED
INSTALLED IN A LATER STEP
VEHICLE FRAME
3