Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295372 & 295373 (RE WINCH) User Manual

Page 5

16. Drill (2 each side) 9/16” holes through bumper

bracket using mounting arm flanges’ inside holes as
guides.

17. Using (2 each side) 1/2-13NC X 1.75 capscrews

(Item #11), (2 each side) lockwashers (Item #22),
(1 each side) nutplate (Item #5), (2 each side) flat
washers (item #23) and (2 each side) nuts (Item
#18), bolt mounting arm and bumper bracket to
vehicle frame.

18. Tighten all remaining bolts to proper torque values

(see Torque chart below).

19. Refer to Winch Owner’s Manual for instructions on

electrical connections. Be sure battery cables are
not drawn taut across any surfaces which could
possibly damage them.

20. Push battery cable into loom (Item #27) and slide

loom up cables as close as possible to mounting
frame assembly. Secure using cable ties (Item #24)
at each end of loom. To improve appearance, wrap
ends of loom with electrical tape.

21. Plug remote switch into receptacle on top of sole-

noid. Run winch forward and reverse to check con-
nections. Snap appropriate “IN” and “OUT” disk into
proper thumb cavity, after determining winch operat-
ing direction. Do not leave switch plugged in when
winch is not in use.

22. Install wire rope according to instructions in the

Winch Owner’s Manual.

Bolt

Torque,

Size

ft-lbs.

1/4-20

5 ft-lbs

7 Nm

3/8-16

34 ft-lbs

46 Nm

1/2-13

87 ft-lbs

118 Nm

12 mm

39 ft-lbs.

53 Nm

Torque Value Chart