Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295372 & 295373 (RE WINCH) User Manual
Page 4
4
NOTE: For the following step, you will require assistance.
10. Place mounting channel (Item #6) between mounting
arm assemblies (items #1 and #2). Use (3 each side)
1/2-13NC x 1.5 capscrews (Item #10), lockwashers
(Item #22), and nuts (Item #18) to attach channel to
mounting arm assemblies.
11. Install grille tube (Item #7) between the mounting arms,
placing shims (Item #26) between mounting arms and
ends of tube. Use (2) 3/8-16NC X 1.0 capscrews (Item
#9).
12. Align channel and mounting arms and tighten front hard-
ware to proper torque values before tightening back hard-
ware (see Torque Value Chart).
FOR WRAP AROUND KIT (P/N 295373) ONLY:
13. Attach Light Tube Assemblies (item #28) to R.H. and
L.H. Mounting Arms using (2 each side) 3/8 Carriage
Bolts (item #29), flat washers (item #31), lockwashers
(item #32), and nuts (item #30). Tighten snugly.
14. Install the fairlead (supplied with winch) to the channel by
pushing (2) 3/8-16NC capscrews (supplied with winch)
with lockwasher (item #19) through fairlead and into
captive nuts in channel. The fairlead should be rotated so
that the smaller set of holes are down as shown below.
Insert the capscrews through the smaller set of holes in
the fairlead. Tighten to 34 ft-lbs. torque.
15. If needed, install the license plate brackets (item #3) to
the underside of the channel using (2) 1/4 self-tapping
screws (item #16) and (2) lockwashers (item #21).
Attach license plate to brackets using (4) 1/4-20NC x .5
screws (item #8), (4) lockwashers (item #21) and (4)
nuts (item #17).
MOUNT FAIRLEAD WITH SMALLER
(7/16") HOLES DOWN AND CHAMFER
AT LOWER LEFT. (FAIRLEAD
SUPPLIED WITH WINCH)