Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295372 & 295373 (RE WINCH) User Manual
Page 2
DO NOT FULLY TIGHTEN HARDWARE UNTIL LATER!
1. Attach (1) nut plate (item #4) loosely to inside of L.H.
mounting arm (item #2) using (2) 1/2-13NC X 1.25 cap-
screws (item #12), (2) flat washers (item #23), and (2)
lockwashers (item #22). See figure at right. Repeat for
R.H. mounting arm (item #1).
2. Remove shipping strap and mounting bolts from winch
assembly and discard. Place mounting channel (item #6)
over top of winch. Secure winch to rear angle of channel
using (3) 3/8-16NC x 1 capscrews (item #9) with lock-
washers (item #19) and (1) 3/8-16NC x .75 socket-head
capscrew (item #14) with Hi-collar lockwasher (item
#20) for each.
3. Attach winch to front of channel using (3) 3/8-16NC x 1
socket-head capscrews (item #13) with Hi-collar lock-
washers (item #20) and (1) 3/8NC x 3/4 socket-head
capscrew (item #14) and Hi-collar lockwasher (item
#20) as shown below. NOTE: The (2) outer-most cap-
screws are inserted through holes in front of channel and
threaded into winch. The (2) inner-most capscrews are
placed into the channel at the fairlead opening and thread-
ed into winch.
Tighten front hardware to proper
torque then tighten back hardware
(for winch mounting only). See
Torque Value Chart.
4. Snap hole plugs (item #25) into
outer-most holes on front of chan-
nel.
2
SHIPPING STRAP
AND MTG. BOLTS
RE-8000, RE-10000, &
RE-12000 SERIES WINCH