Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295372 & 295373 (RE WINCH) User Manual

Page 3

DO NOT FULLY TIGHTEN HARDWARE UNTIL LATER!

5. Remove vehicle tow hooks. Discard existing hardware.

6. Remove L.H. vehicle bumper bracket bolts (2 bolts).

Secure L.H. mounting arm to vehicle frame using (1) nut-
plate (item #5), (2) 1/2-13NC x 1.75 capscrews (item
#11), (2) lockwashers (item #22), (2) flatwashers (item
#23), and (2) nuts (item #18). The nutplates go to the
backside of the frame flange. NOTE: The other pair of nut-
plates are installed at the end of the installation (see step
17).

Hint: To align holes between mounting bracket, bumper
bracket, and frame, you may need to raise or lower the
bumper slightly.

7. Install (3) 1/2-13NC x 1.50 capscrews (item #10) and

(3) lockwashers (item #22) through underside of vehicle
frame and into nutplate (item# 4).

8. Repeat for R.H. mounting arm.

9. Install tow hooks into the ends of the R.H. and L.H.

mounting arms using (3 per side) M12 x 1.75 x 30mm
capscrews (Item #15) and 1/2” lockwashers (Item #22).
Install tow hooks pointing downward.

Out

side mounting

holes in bracket

are slotted