Ramsey Winch FORD GRILL GUARD KIT 295368 - Manual (Page 4)

Note: Installation of the mounting brackets
must be done simultaneously with installing
the bumper on the vehicle. You will need
assistance for this step.
11. Lift bumper into place. While holding bumper in
place, install end of R.H. and L.H. mounting brackets
through bumper and bumper brackets and into vehi-
cle frame. Make sure mounting brackets are
positioned so that slotted holes in flanges are
to the outside.
12. Secure R.H. and L.H. mounting brackets to vehicle
frame using (1 each side) nutplate (Item #4), (2
each side) 1/2-13NC x 1-3/4 capscrews (Item #7),
(2 each side) lockwashers (Item #17), and nuts
(Item #13) on each side. These nutplates go to the
outside of the frame. The other pair of nutplates are
installed at the end of the installation (see step 25).
13. Install (3 each side) 1/2-13NC x 1-1/2 capscrews
(Item #8) and (3 each side) lockwashers (Item
#17) through underside of vehicle frame and into
nutplate (Item #3).
14. Install tow hooks using (3 per side) M12x1.75x
50mm capscrews (Item #12) and 1/2” lockwashers
(Item #17) to the R.H. and L.H. mounting brackets.
4
Outside mounting
holes in brackets
are slotted