Ramsey Winch FORD GRILL GUARD KIT 295368 User Manual

Page 3

6. As shown at right, if the truck is equipped with fog

lights, remove clip for fog light electrical harness
from inside of frame. Tie off fog light electrical har-
ness further back.

7. Remove factory bolt and nut from frame and install

(1 per side) 7/16-14NC X 1-1/2” capscrew (Item
#11), 7/16 nut (Item 14), and lockwasher (Item
#16) with bolt reversed in frame (so that bolt is
pointing outward). Repeat for other side.

NOTE: Some models may not have these factory
bolts. If there is no factory bolt, skip this step.

8. Enlarge rectangular cutout in bumper bracket by 3/4”

at top and 1/4” at bottom as shown below. The fin-
ished bracket will appear as shown middle right.

9. Remove air dam.

10. Attach (1 each side) nut plate (Item #3) loosely to

inside of each Mounting Bracket Assembly (Items
#1 and #2) using (2 each side) 1/2-13NC X 1-1/4
capscrews (Item #9), (2 each side) washers (Item
#18), and (2 each side) lockwashers (Item #17) on
each assembly. See illustration at right.

REMOVE CLIP FOR
FOG LIGHT ELEC-
TRICAL HARNESS

REMOVE FACTORY BOLT
AND NUT. REPLACE
WITH SUPPLIED BOLT
AND NUT, REVERSED.