Ramsey Winch DODGE GRILL GUARD KIT 295370 (RE WINCH) - Manual (Page 6)

10. Align the mounting kit and tighten all screws to the values
listed in the Torque Value Chart at right. Work from the
bottom of the mounting kit up.
11. Once the mounting kit is tightened up, place the
mounting angle (item 2) between the mounting arm
(item #7) and the vehicle frame. The mounting angle
needs to be snug against both. Clamp the mounting
angle and mounting arm together, and mark drill hole
locations on the mounting angle (see figure above).
Drill 0.515” thru holes at the marked locations.
Install the mounting angle to the mounting arm using
(2) 1/2-13NC capscrews (item #10), nuts (item
#16), and lockwashers (item #20). Tighten according
to Torque Value Chart above.
Repeat for other side.
12. Refer to Winch Owner’s Manual for instructions on
electrical connections. Be sure battery cables are not
drawn taut across any surfaces that could damage
them.
13. Push battery cables into loom (item #23) and slide loom
up cables as close as possible to mounting frame assem-
bly. Secure using cable ties at each end of loom. To
improve appearance, wrap ends of loom with electrical
tape.
14. Plug remote switch into female receptacle and confirm
that winch operates. Install cable according to instructions
in Owner’s Manual.
6
Bolt Torque, Torque,
Size ft-lbs. Nm
1/4-20 5 ft-lbs 7 Nm
3/8-16 34 ft-lbs 46 Nm
1/2-13 87 ft-lbs 118 Nm
12mm (factory) 39 ft-lbs 54 Nm
Torque Value Chart
Mounting
Arm
Frame
Mounting
Angle