Ramsey Winch RPH-25000 - Manual (Page 8)

8
4. Remove winch from upright
mounting frame (item #1) by
removing (4) capscrews and
lockwashers. Pull motor end
bearing (item #8) from drum
assembly (item #2).
5.
Pull drum assembly (item #2) upward from end bearing (item #9). Remove quad-rings (item #39 & #38) from grooves in
drum bushings. Remove input shaft (item #11), clutch spring (item #45) and washer (item #27) from end bearing (item
#9). Examine splined ends of input shaft for signs of wear, replace if damaged.
Examine drum assembly (item #2) for signs of wear. If splines inside of drum driver (332166) are damaged, drum driver
must be replaced. Remove drum driver by unscrewing (8) capscrews (414462). Place well-oiled o-ring (462053) into drum
driver groove and attach driver to drum (332165) using (8) capscrews (414462). Torque capscrews to 55 ft. lbs. each, in
criss-cross pattern.
Press old bushings from drum and drum driver. Remove o-rings (462055 & 462052) from grooves in drum and drum
driver-bushing (412092). Place well-oiled o-rings (462055 & 462052) into grooves in drum and outer diameter of drum
driver bushing (412092). Press new bushing (412091) into end of drum opposite drum driver and press bushing (412092)
into drum driver until flange of bushings are flush against drum and driver. Secure bushings to drum and drum driver using
(2) capscrews (414819).
25 16
1
16 25
17 25
9
2
17 25
8
DRUM ASSEMBLY 234170 (ITEM #2)
46
9
28
11
10
39
40
2
412091
414819
412092
462052
332166
462053
414819
GROOVE
DRUM DRIVER
462055
332165
414462