Ramsey Winch RPH-25000 - Manual (Page 11)

11
12. With pin (item #44) installed in coupling, slide coupling (item #5) over end of input shaft
below. Slide coupling over end of shaft (item #12). Place gasket (Item #34) into
position on motor mounting surface of end bearing (item #8). Insert brake shaft into
coupling. Use (2) screws (item #21) to attach brake assembly to motor end bearing.
Torque capscrews to 85 ft lbs each.
13. Attach motor (item #37) with well oiled gasket
(item #32) to brake (item #31). Use (2)
capscrews (item #20) and torque to 74 ft. lbs.
each. Securely connect tube (item #46) to elbow
(item #29), in valve (item #47), and brake (item
#31).
14. Apply Permatex to threads of pipe cap (item #43).
Thread pipe cap onto pipe nipple in bottom of gear
housing end bearing (item #9). Pour approx. 1.75
pints of SAE 80W-140 oil into end bearing. Check oil
level by removing oil plug noted below. Insert relief
fitting (item #35) and thread reducer (item #41)
into end bearing at oil fill hole.
Install winch and connect pressure lines. Apply at
least 230 PSI pressure to release brake and verify
that brake releases, by observing that the winch
drum rotates.
15. Check proper operation of clutch by applying air
pressure to clutch air cylinder to disengage clutch.
Verify that winch freespools. Re-engage clutch. A
loud noise should be heard when clutch engages.
Winch drum should not freespool.
16. Operate winch forward and reverse to verify that
drum rotates.
35
8
10
5
20
32
33
30
48
30
19
19
38
47
FITTING
BLEEDER
42
36
44
37
OIL FILL HOLE
9
OIL LEVEL HOLE