Ramsey Winch RPH-16000 - Manual (Page 9)

7
INSTRUCTIONS FOR OVERHAUL OF RAMSEY WINCH
MODEL RPH 16,000
DISASSEMBLY
TAKE NOTE of mounting configuration for proper mounting of parts during re-assembly. Replace all gaskets, o-rings, and seals
with new ones during re-assembly.
STEP 1
Disconnect hose (item #44) from elbows
(item #26) on brake housing (item #7)
and valve (item #45). Remove motor
(item #31) and motor spacer (item #49)
from brake housing (item #7) by un-
screwing capscrews (item #20). Tap
motor lightly to disengage.
Remove coupling (item #25) from brake
housing. Examine coupling for signs of
wear, replace if necessary. If necessary
remove valve (item #45) from motor by
removing capscrews (item #16). If valve
is removed make sure the two O-rings
remain seated in their counter bores in
valve.
STEP 2
Remove brake housing (item #7) from end
bearing (item #3) by unscrewing (6) cap-
screws (item #17) in a criss-cross pattern
(two turns each) until all capscrews are re-
moved from brake housing. Examine brake
discs (item #27) for signs of wear and re-
place if necessary. Examine O-rings (items
#33 an #34) and backup O-rings (items
#35 and #36) for signs of wear. Remove O
-rings and backup O-rings from brake piston
(item #4).
Remove and examine springs (items #42
and #43) for damage, replace if necessary.
Examine fitting (item #30) to assure that
fittings are in proper working condition,
replace if necessary.