Ramsey Winch RPH-16000 - Manual (Page 13)

11
STEP 7
Place gaskets (item #29) into position on mounting surface of motor (item #31) and motor spacer
(item #49). Slide motor shaft into coupling (item #25) and attach motor to brake housing (item #7). Use (2)
capscrews (item #20) with lock washers (item #24) and torque to 87 ft.lbs. (118 Nm) each. NOTE: If valve
(item #45) was removed from motor, re-install at this time using (3) capscrews (item #16). Make sure that O
-rings are in grooves on bottom side of valve that mounts to motor. Torque capscrews (item #16) to 40 ft.lbs.
(54 Nm) each. Securely connect hose (item #44) to elbows (item #26) in valve (item #45) and in brake
housing.
Apply at least 550 PSI hydraulic pressure to release brake and verify that brake releases by observing that the
winch drum rotates.