Ramsey Winch RPH-10000X User Manual
Page 15
13
Before installing motor, check brake adjustment (refer to page 7, ADJUSTING THE BRAKE).
Place splined end of coupling (item #31), with spirol pin installed, inside of motor end
bearing housing (item #7) and slide over splines on end of input shaft. Place o-ring (item
#38) around motor pilot. Mount motor (item #35) to end bearing by aligning key on motor
shaft with keyway in coupling. Be sure that motor mounts flush to end bearing and that o-
ring is set securely in place between motor and end bearing. Secure motor to end bearing
using two capscrews and lockwashers (items #24 & #30). Tighten capscrews to 49 Ft. Lbs.
(66 Nm). Thread plug (item #40) into bottom of brake housing. Permatex can be added to
threads of plug to help in sealing. Pour a mixuture of 8 oz. of Mobilfluid 424, Phillips HG
Fluid, Texaco TDH, Shell Oil Co. Donax TD high performance tractor transmission fluid, or
equivalent and 1/4 oz. of an additive (available from the factory), into oil level hole. Oil level
should be kept at oil level hole (plus or minus 1/8"). Thread plug (item #40) into oil level
hole. Insert reducer (item #39) into hole in top of brake housing and breather plug (item
#34) into reducer. Tighten plugs and reducer securely.