Ramsey Winch RPH-10000X - Manual (Page 11)

9
Remove tie plates (item #13) from end bearings (items #7 & #8) by unscrewing capscrews (item #18), as
shown. Slide motor end bearing (item #7) from drum (item #1) and drum from gear housing end bearing
(item #8). Remove input shaft (item #12) from end bearing. Inspect teeth of gear (item #5) for signs of
wear. If necessary replace gear by removing snap ring (item #47) and thrust washer (item #50) . Slide new
gear over splines of shaft and against snap ring on shaft. Re-install thrust washer and place snap ring into
groove of shaft.