Ramsey Winch RPH 45000 OVERWOUND W/ AIR TENSIONER & 2 SPEED MOTOR - Manual (Page 14)

12
14. Apply Permatex to thread of plug #44.
Thread plug into tapped hole in bottom
of gear housing end bearing #10. Pour
approximately 4.75 pints of SAE 80W-
140 oil into end bearing. Check oil level
by removing oil plug noted below.
Insert relief fitting #39 and thread
reducer #43 into end bearing at oil fill
hole. Be sure breather vent #39 and
relief fitting #43 are not damaged and
in good operating condition. Replace if
necessary.
Install winch and connect pressure
lines. Apply at least 230 PSI pressure
to release brake and verify that brake
releases, by observing that the winch
drum rotates.
15. Check proper operation of clutch by
applying air pressure to clutch air
cylinder to disengage clutch. Verify that winch freespools. Re-engage clutch. A loud noise should
be heard when the clutch engages. Winch drum should not freespool.
16. Operate winch forward and reverse to verify that drum rotates.
40
OIL LEVEL PLUG
39
44
10
43
WINCH MOUNTING CONFIGURATIONS
R. H. MOUNTING
CONFIGURATION
L. H. MOUNTING
CONFIGURATION