Ramsey Winch RPH 45000 OVERWOUND W/ AIR TENSIONER & 2 SPEED MOTOR - Manual (Page 10)

8
6. Remove output coupling #6 and coupling shaft #7 from end
bearing #10. Examine bearings #14 pressed in output
coupling for signs of wear. Replace bearings, if necessary, by
pressing old bearings from coupling and press new bearings
into each end of output coupling. Place coupling shaft into
bearings.
7. Remove (12) capscrews #18 to pull gear-housing cover
and gasket from ring gear. Remove input thrust washer, sun
gear and carrier assemblies from inside of ring gear. Remove
ring gear #4 and gasket #36 from end bearing #10. Examine
shifter shaft #13 for signs of wear, replace if necessary.
Examine bushing #15 for signs of wear. Replace bushing, if
necessary, by pressing old bushing from housing and
pressing new bushing into place.
10
6
7
14
14
10
13
15
18
36
54
36
4