Ramsey Winch HD-234 - Manual (Page 14)

15. Place gasket (item #27) onto adapter
(item #1). Slide seal (item #37) onto
worm. Slide tapered end of coupling
(item #25) over end of worm shaft.
Attach adapter and coupling to gear
housing using four screws (item #21).
Tighten screws to 12 ft-lbs. (16.3
Nm) each.
16. Place winch with gear housing cover down on
work bench. Drum shaft should be in vertical
position. Slide thrust washer (item #42) over
drum shaft and slide downward until washer
rests on gear housing. Set springs (item #40)
into pockets of gear housing with drag brakes
(item #26) on top of springs. Slide drum
assembly (item #5) onto drum shaft with
drum jaws upward.
14
37
27
1
21
25
5
42
40
26