Ramsey Winch HD-234 - Manual (Page 12)

10.Check clutch housing bushing (item #18)
for wear. If necessary, remove old bush-
ing and press new bushing into place.
Check yoke (item #15) for damage. Yoke
should be firmly attached with setscrew
(item #24). Apply grease to lube fittings
(item #31) to lubricate clutch shifter
shaft (item #12).
11. Check cover bushing (item #18) for signs
of wear. If necessary remove old bushing
and press bushing into place.
12. Apply grease to end of shaft, opposite gear. Apply grease to bushing in gear housing
(item #8). Place greased end of shaft through thrust washer (item #42) and bushing in
gear housing (item #8). Place gasket (item #28) onto gear housing cover (item #4).
Apply grease to gear end of shaft and cover bearing. Place cover onto shaft and secure
to housing with ten capscrews (item #20). Tighten capscrews to 8 ft-lbs. (10.8 Nm)
each.
RE-ASSEMBLY
12
7
18
6
4
20
28
42
13
8