Ramsey Winch HD-234 LEVER STYLE User Manual

Page 15

17. Place thrust washer (item #43) over end of drum shaft and slide down-

ward until space rests on drum. Press drum downward to compress
springs in gear housing.

Insert keys (item #29) into keyways with sharp edge of keys pointing
outward and notched end of keys upward. A rubber or brass mallet will be
needed to gently tap keys into position.
Apply grease to keys and end of shaft. Place jaw clutch (item #3) over
end of shaft and slide jaw clutch over keys.
Set clutch housing (item #7)
over end of drum shaft. Pull
jaw clutch (item #3) up-

ward, toward clutch hous-
ing, enough to allow yoke,
in clutch housing, to fit
properly in groove around jaw
clutch.

18. Insert plug (item #34) into bottom of gear housing. Permatex may be

applied to threads to help prevent leakage.

Pour 3/4 pint of Phillips SMP 80W-90, Mobil HD 80W-90, Shell Spirax
HD 80W-90, or CITGO MP 80W-90 gear oil only into housing through
hole in top of housing. Insert relief
fitting (item #32) into reducer
(item #33). Reducer should
then be placed into hole on

top of gear housing. Tighten
fitting and reducer securely.