Ramsey Winch HD-234 LEVER STYLE - Manual (Page 11)

8
6. Remove gear housing cover
(item #4) from gear housing
(item #8) by unscrewing
capscrews (item #20).
Thread two of the capscrews
into the two tapped holes
of cover and tighten. This
will pull the cover loose
from the gear housing.
Remove cover gasket (item #28) and pull
shaft (item #13), with gear attached, and thrust washer (item #43) from
gear housing.
7. Check for signs of wear on gear
teeth. If replacement of gear is nec-
essary, replace as follows:
a) Press gear (item #6) from
shaft (item #13).
b) Examine shaft keys and key-
ways. If distortion of keys and/
or keyways is evident, shaft
and keys should be replaced.
c) Use a soft hammer to gently
tap keys (item #30) into keyways. Press gear (item #6) over shaft
and keys. Gear must be centered over keys.
8. Remove seal (item #39) from back
of gear housing (item #8). Press
bushing (item #19) from gear
housing. Press new bushing and
seal back into place.
9. Check drum bushings (item
#18) for signs of wear. Replace
if necessary by pressing old
bushings from drum. Press new
ones into place.
8
43
13
28
20
4
6
30
13
6
30
39
8
19
18
5
18