Ramsey Winch HD-234 LEVER STYLE - Manual (Page 14)

11
15. Place gasket (item #27) onto adapter (item #1). Slide
seal (item #38) onto worm. Slide tapered end of cou-
pling (item #25) over end of worm shaft.
Attach adapter and coupling to gear
housing using four screws (item
#21). Tighten screws to 12 ft-lbs.
(16.3 Nm) each.
16. Place winch with gear housing cover down on
work bench. Drum shaft should be in vertical
position. Slide thrust washer (item #42) over
drum shaft and slide downward until washer rests
on gear housing. Set springs (item #41) into
pockets of gear housing with drag brakes (item
#26) on top of springs. Slide drum assembly
(item #5) onto drum shaft with drum jaws
upward.
25
21
1
27
38
42
5
26
41