Ramsey Winch DC-300 RAM-LOK - Manual (Page 17)

15
17. Press bearing (item #24) onto worm (item #23)
NOTE: Be sure thick shoulder of bearings outer
race (side with manufacturer’s name and part
number) is out, away from worm threads. Press
bearing and worm into gear housing. Slip gas-
ket (item #43) onto bearing cap (item #6).
Use four capscrews (item #29) to secure cap to
gear housing. Torque capscrews to 8 ft. lb. (10.8
Nm .) each.
Attach solenoid assembly ( item #2) to gear
housing. Use two (item #34) capscrews and
three (item #30) capscrews with three fl atwash-
ers (item #40). Tighten capscrews to 8 ft. lb.
(10.8 Nm ) each. Insert plug (item #56) into
tapped hole of cover. Permatex may be applied
to threads to help prevent oil leakage.
TIGHTEN plug securely.
18. Press bearing ( Item #24) onto worm and into
worm gear housing. NOTE: Be sure thick shoul-
der of bearings outer race (side with manufac-
turer’s name and number) is out, away from
worm threads. Place gasket (item #43) onto
spur gear housing (item #16). Secure spur gear
housing to worm gear housing using four cap-
screws (item #33). Torque capscrews to 8 ft. lb.
(10 .8 Nm.) each.
Mount motor (item #51) to spur gear housing
(item #16) using three lockwashers and nuts
(items #39 & #41). Attach solenoid cables to
motor terminals. Tighten all nuts securely.