Ramsey Winch DC-300 RAM-LOK User Manual

Page 13

4. Slide clutch housing (item #17) from end of drum
shaft. Slide jaw clutch (item #7) from end of drum
shaft

Remove (2) keys (item #47) from keyways. A
screw driver can be used, at notch, to aid in re-
moval of keys. Once keys have been removed,
drum (item #10) and thrust washer (item #70) can
be removed from drum shaft. Parts under drum,
thrust washer (item #69), spring and disc (items
#66 & #42) should also be removed.

5. Remove bearing cap (item #6) from gear housing
by unscrewing four capscrews (item #29). Remove
worm (item #23) and bearing (item #25) from gear
housing . Use a soft hammer to gently tap input
end of worm and drive worm and bearing from
gear housing. Once worm has been removed
from housing, bearing can be pressed from end of
worm.

Check for signs of wear to worm (item #23) and
bearings (item #25). Replace if necessary. For
models with optional worm brake refer to page 5,
SERVICING OF THE OIL COOLED SAFETY
BRAKE,for disassembly and page 6, for
re -assembly instructions .

6. Remove gear housing cover (item #8)
from gear housing (item #18) by un-
screwing

fi ve remaining capscrews

(item#29). Place capscrew into two
tapped holes of cover and tighten. This
will pull the cover loose from gear
housing

Remove cover gasket (item #45) and
pull shaft (item #22), with gear at-

tached, and thrust washer (item #70)
from gear housing.