Ramsey Winch GEARBOX REPLACEMENT KIT RAMSEY/AUBURN TO QGBX RPH20/25 256115 - Manual (Page 5)

10.Attach motor (item #38) with well oiled
gasket (item #7*) to brake (item #32).
Use (2) capscrews (item #19) and torque
to 74 ft. lbs. each. Securely connect tube
(item #47) to elbow (item #30), in valve,
and brake (item #32).
11.Slide washer (item #26) over setscrew and
against nut attached to air cylinder rod.
Install air cylinder into gearbox cover mak-
ing sure the setscrew in end of cylinder rod
goes in hole in end of shifter shaft. Apply
Loc-tite PST thread sealer to threads of cap-
screws (item #24). Attach air cylinder and
new gasket (item #6*) to end bearing
assembly using (4) capscrews (item #24).
Torque capscrews to 60 in-lbs. each, in
criss-cross pattern.
Apply Permatex to threads of pipe cap (item
#44). Thread pipe cap onto pipe nipple in
bottom of gear housing end bearing. Pour
approx. 1.75 pints of SAE 80W-140 oil into
end bearing. Insert relief fitting (item #36)
and thread reducer (item #42) into end
bearing at oil fill hole.
Install winch and connect pressure lines.
Disengage clutch and verify that winch
freespools. Engage clutch and run winch to
verify that clutch fully engages and that
drum rotates in both directions.
7*
38
19
47
19
30
32
5
AIR CYLINDER
44
26
6*
42
36
24
OIL FILL LEVEL