Ramsey Winch GEARBOX REPLACEMENT KIT RAMSEY/AUBURN TO QGBX RPH20/25 256115 - Manual (Page 3)

6. From new Gearbox Replacement kit, place Gear End Assembly (item
#2*) on workbench with gearbox cover down (as shown at right).
Slide shifter shaft (item #4*) with washer (item #5) over it into the
Gear End Assembly, with long splined end going in first. Mesh
splines with input sun gear in gearbox. About 1/2” of the end of the
shifter shaft should protrude through gearbox cover when it is all the
way in.
Insert the shaft coupling (item #3*) into the shifter shaft and then
insert the output coupling assembly (item #1*) over it.
Place a second washer (item #5*) on the output coupling assem-
bly.
7. Insert the input shaft (item #11), clutch spring (item #46), and coupling
(item #5) into the gear end assembly. Carefully set drum assembly (item
#1) on gear end assembly.
Secure drum to gear end assembly using C-clamp.
3
5*
1*
3*
5*
4*
2*
Item numbers denoted with * are from
the Gearbox Replacement kit.
10
11
1
5
46
5*