Ramsey Winch GEARBOX REPLACEMENT KIT RAMSEY/AUBURN TO QGBX RPH20/25 256115 - Manual (Page 2)

3. Remove brake assembly (item #32) by removing (2) mounting screws (item
#20) that attach brake to end bearing (item #8). Remove gasket (item #35)
from end bearing.
4. Take note of mounting configuration
for proper mounting of parts during
re-assembly. Remove winch from upright
mounting frame (item #2) by removing
(4) capscrews and lockwashers. Pull
motor end bearing (item #8) from drum
assembly (item #1).
10
8
20
32
35
2
9
1
8
17 25
17 25
25 16
25 16
2
11
9
10
1
5
46
28
5. Pull drum assembly (item #1) upward from end bearing (item #9). Remove
coupling (item #5), input shaft (item #11), and clutch spring (item #46) from
gear end assembly.
Set aside drum assembly, coupling, input shaft, and clutch spring.
Discard gear end assembly.