Ramsey Winch REP-6000/8000/9000 CURRENT - Manual (Page 7)

7
Repositioning Shifter for Specific Bull Bar Applications
Note: The shifter is positioned correctly for most applications. It will only need to be repositioned as necessary for
specific bull bar applications.
Refer to the Parts List and Exploded Parts Diagram for your specific winch elsewhere in this owner’s manual.
1. Position winch as shown in Figure 6. Remove screws from tiebars. You may be able to loosen the screws at the
motor end without removing them. Pull the Gear Housing assembly from the drum and shaft and set it down on
the work bench with the Gear Housing Cover up. Remove the drum bushing from the Gear Housing assembly or
the end of the drum. Set aside.
2. Remove (6) capscrews from the Gear
Housing Cover. Holding the Gear
Housing Cover over the Gear Housing
assembly, flip it over and set it on the
workbench.
3. Gently lift the Gear Housing assembly,
working the gears, bushings, etc. that are
inside the Gear Housing out so that they
are left stacked on the workbench. See
Figure 8.
4. Turn the Gear Housing assembly over and
set on workbench. Remove the Retainer
(item #37) by removing six capscrews
(item #21) from Gear End Bearing (item
13). Once the retainer is removed, the Ring
Gear (item #10), Cam Ring (item #36),
and Locking Ring (item #34) can be lifted
off the end bearing.
Remove the six springs (item #38) from
the end bearing.
3
28
1
23
2
40
10
40
17
41
16
12
29
11
39
21
13
38
36
34
10
37
FIGURE 7
FIGURE 9
FIGURE 8