Ramsey Winch QM-9000 for H2 - Manual (Page 4)

Assembling Your Winch
To assemble the QM-9000 winch to the quick mount channel,
attach the handles to both ends of the quick mount channel
using (2) black 3/8” button head screws for each handle.
Tighten to 20 ft-lbs. torque.
Once the handles are attached, lift the winch into the quick
mount channel. Feed the looped end of the pre-wrapped cable
through the fairlead.
Place a 3/8” nut and flatwasher in each of the feet. Align the
four mounting holes in the quick mount channel with the feet
of the winch. Place a lockwasher on each 3/8” hex head
screw and then press a screw through each mounting hole
and start it through a nut. Do not tighten until all of the screws
have been started. Tighten to 34 ft-lbs. torque.
Align the base of the clevis hook with the loop on the end of
the cable. Run the pin through the clevis hook and the loop.
Push the cotter pin through the hole in the pin and bend the
cotter pin to lock.
4
34 ft-lbs.
torque
20 ft-lbs.
torque
FOR FRONT MOUNT
FOR REAR MOUNT