Ramsey Winch ATV-2500 - Manual (Page 19)

Rocker Switch
Operation
Press Rocker Switch
toward “IN” position to
spool cable “IN” and
press Rocker Switch
toward “OUT” position
to spool cable “OUT”.
Rocker Switch Installation
The Rocker Switch will mount to the handle bars
of the ATV.
Before Beginning Installation
1. Install mounting kit and winch according to
the mounting kit instructions.
2. Disconnect negative (-) battery cable
from battery. Turn off vehicle ignition.
3. Disengage winch clutch.
4. Remove hood or cowling as necessary for
easier access to installation area.
5. Locate and mark mounting location for
Solenoid Assembly.
6. Locate accessory wire from vehicle ignition
switch that is powered only when ignition is
ON. Use this wire when splicing to Red wire
on Rocker switch.
7. Make sure locations are close enough for
wiring connections to be made without mak-
ing alterations to wire lengths.
C
AUTION
: D
O NOT CONNECT NEGATIVE BATTERY CABLE OR
ENGAGE CLUTCH UNTIL INSTALLATION IS COMPLETE
. W
INCH
COULD BEGIN SPOOLING CABLE UNEXPECTEDLY CAUSING
INJURY OR DAMAGE TO WINCH
.
Solenoid Mounting: Choose a mounting location
that will remain protected and dry. Solenoid
should be mounted on a flat surface.
Installing the Solenoid
1. Use Solenoid Assembly as a guide to mark
and drill (2) 7/32” holes in location deter-
mined for solenoid.
2. Use (2) 3/4” long #10 capscrews (item
#14-3), (2) #10 flat washers (item #14-8),
and (2) #10 locknuts (item #14-5) to mount
solenoid. Tighten to 60 in-lbs (7 Nm) torque.
Installing the Rocker Switch
For clarification, see wiring schematic on page
18.
1. Position Tube Clamp (item #14-12) on handle
bars in convenient location.
2. Mount Rocker Switch housing to Tube Clamp
using #10 capscrew, locknut, flat washer,
and shake-proof washer (items #14-3, #14-
5, #14-8, and #14-9). Tighten securely.
19