Ramsey Winch ATV WIRELESS REMOTE FOR BADGER 2500 User Manual

Page 6

BADGER 2500 WIRELESS REMOTE INSTALLATION

Before Beginning Installation

1. Disconnect power lead from winch to battery.

2. Disengage winch clutch.

3. Remove covers as necessary for easier access to installation area.

4. Locate & mark mounting locations for receiver, toggle switch, solenoid

assembly, & antenna.

5. It is recommended that a 5-amp SPST power switch be installed

between the battery power and the receiver to turn off power to the
receiver when not in use. Customer will need to furnish switch, then
locate and mark a mounting location for it.

NOTE: Make sure locations are close enough for wiring con-
nections to be made without making alterations to wire
lengths. Antenna must be mounted on firm, flat steel or iron
surface like the hood of a vehicle or frame of a trailer.

Installing the Receiver

NOTE: For clarification see wiring schematic on page 4.
1. Insert plastic tie through mounting ears on receiver and secure receiv-

er to location determined above under “Before Beginning Installation”.

2. Tighten plastic tie and clip excess.

3. Attach ground wire to frame or other grounded surface.

Caution: Do not alter the length of the ground wire as this
will affect performance of the remote.

4. Attach wiring harness to receiver & route yellow and green wires to

solenoid location.

Note: It is recommended that a switch be installed as shown
on Electrical Schematic so that power to receiver can be
turned off when not in use.

BADGER 2500 WIRELESS REMOTE INSTALLATION

Installing the Motor Leads
NOTE: For clarification see wiring schematic on page 4.
1. Connect black wire to #2 stud on motor.

2. Connect black with yellow stripe wire to #1 stud.

3. Route wires to solenoid location.

Connecting Wiring to Solenoids
1. Attach black with yellow stripe motor lead to lower right terminal stud

“B” on solenoid.

2. Attach black motor lead to lower left terminal stud “C” on solenoid.

3. Attach connector with 2 yellow wires to the terminal directly above the

black with yellow stripe motor lead.

4. Attach connector with 2 green wires to the terminal directly above the

black motor lead.

5. Attach black battery lead to upper left terminal stud “E” on solenoid.

6. Attach red battery lead to upper right terminal stud “A” on solenoid.

Installing the Solenoid
1. Mount solenoid in location determined previously.

2. Secure using (1) tube clamp, (1) #10-24 screw, (1) flat washer, and

(1) lock nut on each side of solenoid assembly.

CAUTION: Be sure that no wire connections are in contact
with either the frame/grounded surface or with each other as
a direct short will occur.

Installing the Toggle Switch
1. Route red, yellow, and green wires to toggle switch location .

2. Drill 1/2” hole in location for toggle switch installation.

3. Insert switch through hole drilled in previous step.