Alliance Laundry Systems UW125AV - Manual (Page 14)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
F232226 12
The washer-extractor has 5 supply compartments,
designated as compartments 1, 2, 3, 4 and 5.
Compartment 1 is farthest to the rear of machine.
Moving toward the front of machine, compartments
are ordered 2, 3, 4 and 5 (at the front of machine).
Supply signals 1 through 5 correspond to
compartments 1 through 5. Supply signals 1, 2, and 3
have dedicated water valves that flush compartments
1, 2 and 3 (along with the signal being available for
external supplies). Supply signal 4 operates a valve
that flushes compartment 4. The supply signal is
available for external supply connection. This valve is
connected so that it also flushes supply compartment 5
when the supply 4 signal is on. For example, if supply
4 signal is programmed, it will flush compartments 4
and 5. Supply 5 is available to operate an external
supply.
NOTE: For additional assistance, refer to
installation instructions.
Temperature Controlled Fill
Display shows temperature in degrees F or C. Display
will show degrees F if configured for “FAr” in Setup
Mode, or degrees C if configured for “CEL” in Setup
Mode. Range is 75°F to 200°F, or 00F (no heat for
segment), or 25°C to 93°C, or 00C (no heat for
segment).
Press the
∧ keypad to increase, or ∨ keypad to
decrease temperature. Temperature changes in one-
degree increments. The control will energize heat and
pause cycle timing for up to 40 minutes until the
programmed temperature is first reached.
NOTE: If temperature not reached after
40 minutes, control resumes cycle.
After cycle resumes, control will attempt to maintain
programmed temperature if it senses water in the
machine.
If display shows “drAI”/“nodr” during segment
programming, a drain step option can be selected.
Select “drAI” for a drain step followed by an optional
spin. Select “nodr” for no drain step. The machine will
proceed directly to the next segment if “nodr”. Change
the selection by pressing the ∧ or ∨ keypad. Press
START to continue.
If “drAI” is selected (or if your model does not provide
the option of selecting “drAI”/“nodr”), the display will
show “SPIn” one second, “tI
n
E” one second, and then
the time for spin: “00” (no spin) for 60-240 seconds IF
you are in Rinse 1 – 5. If you are in Rinse 6, the time
for spin will show 0 or 1-10 minutes. Change the
selection by pressing the ∧ or ∨ keypad. Press
START to continue.
IMPORTANT: The spin time in Rinse 6 is
programmed in minutes (0-10 minutes, in
one-minute increments), while other spins are in
seconds to allow for shorter times (such as
45 seconds). (Rinse 6 segment should usually be
used as the final rinse, even where there may be
fewer than four rinses. Program zero time for
preceding rinses you wish to exclude.)
Display shows “0000” temperature. Exit Program
Mode by moving the Program/Run switch back to the
left as seen from the front of the machine.
NOTE: The SPIN indicator LED will automatically
light during the wash cycle when the last spin
programmed in a cycle is operating (regardless of
which segment).